Garage Door Opens Part Way And Stops

Some older garage door openers do not have nicely labeled adjustment screws for force and travel limits.

Garage door opens part way and stops. If this setting is improper it can cause your door to stop midway thinking its job is done. A faulty logic board could also be a reason your garage door opens then stops. The logic board receives and responds signals to any remote. Doing this can save you some amount of cash.

You push the button to close the garage door. It goes partway down reverses direction and goes back up again. In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor. The garage door can be operated manually by disconnecting the garage door opener from the door using the red pull cord.

Your automatic garage door comes with a limit setting that limits the amount of force it is allowed to exert in either opening or closing. This is almost always the result of a dirty or obstructed safety feature. Depending on how old your garage door opener is you may want to replace it if it s old. Over time sometimes through natural settling this setting can get out of appropriate caliber.

This board electrically controls your garage door and will fail if it shorts out. You might need to consider replacing it if your door is not working properly or you may purchase a new opener. If the door reverses part way down and you are sure there is no obstruction or binding increase the closing force a small amount and try it again. This indicates that the springs torsion springs in the case of the photo above are working properly and are not the issue.

This requires a simple turn with a screwdriver to reset the limit so the garage door opens and closes all the way again. If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch. On the other hand if your opener is fairly new you may want to call a professional.