Garage Door Side Spring Adjustment Instructions

Use a metal rod to stick in the first notch of the cone.

Garage door side spring adjustment instructions. The cone is on the torsion spring on the left side away from the. The springs extend along the shaft and work by twisting as the garage door closes by means of cables attached to each side of the lowest garage door panel. Adjust the spring into the proper position and make sure your garage door closes all of the way. Do not use a digital scale as they often will not respond to the door weight changing as rollers no longer stick to the track.

The stops on your garage door are rubber seal that runs along the edges of your garage door. To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller. Side mounted springs are long heavy springs mounted on each side of the upper garage door track. Place scale under the garage door on the side of the door with the broken extension spring.

Adjust your limit. The rod will need to be at least 18 inches long and 1 2. If not this will be creating gaps around your. Release your hold on the door and see if it stays up all the way.

One end of the spring is connected to the garage door track or frame. Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension. How to adjust a garage door gap 1. Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out.

How to adjust a torsion spring garage door step 1. The other is attached to a pulley connected to the cable. Ideally the door should slowly float up from this point. When the door is closed is it perfectly vertical.

Look for a reddish cone on the torsion spring. If it was opening too quickly move it to the next lower hole. Adjust the springs on both sides of the door the same way. Look at the tracks.

This tension makes it easier to lift the garage door from its closed position. Retest the door. Slowly close your door about halfway and release it. Hold the garage door and remove the vise grips from the track after the spring tension has been adjusted.