Garage Door Spring Does Not Stay Tight

Be sure not to twist the garage door cable when reattaching the pulley.

Garage door spring does not stay tight. If it stays in place your spring or springs are fine. Close the garage door and pull the emergency release. A pulley through which the garage door cable is threaded. 2 brace the open door.

Release your hold on the door and see if it stays up all the way. One of the more difficult problems for do it yourselfers to diagnose is a worn cable pulley on an extension spring door. Hold the garage door and remove the vise grips from the track after the spring tension has been adjusted. Lift the door manually to about waist height bring it to a stop and let go of it.

Click on a problem below to see the possible causes and solutions. Simply disconnect these two attachments and reattach the new spring in the same way. A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem. Another thing that can reveal a broken torsion spring is a loud bang emanating from your garage.

There are of course many other problems that can keep your garage door from functioning properly. This will disconnect the opener from the door and allow you to open it manually. Ideally the door should slowly float up from this point. If the tension is too loose the springs that help lift the door are ineffective and the weight of.

Bottom of the door is up on one side. Move the garage door up and down until you find a place where the door stays suspended when you let go. Garage door springs offset the weight of the door and allow it to open and close with ease. Slowly close your door about halfway and release it.

If that point is more than four feet or less than three feet above the ground you will need to balance the door.