Ge Washer Door Locked Wont Shut

Door lock can fail either mechanically or electrically.

Ge washer door locked wont shut. No water in the washer filter is clean. If the water does not drain from the unit it tells the main control board that it is not empty and locks the door until it gets the signal that the unit is empty. The washing machine door won t close or block if the washing machine latch won t close most often something is preventing it from closing. If the door lock is defective the washer door will not latch properly.

If the door lock is damaged or does not latch properly replace it. I show the symptoms. The problem is that the machine won t start washing as it will not. If the blocking does not occur it means the mechanism is broken.

Next turn the timer knob around once and into any setting other than final spin. To lock the washer press and hold the lock button for 10 seconds. For other ge washing machine models you will also start by unplugging or shut off power to the washer for 30 seconds. The control lock icon on the display will light up when it is on.

The wax motor style of solenoid normally takes at least a minute or two to activate or deactivate. The door lock secures the washer door shut during operation. When the cycle is started the washer control will activate the lock solenoid wax motor to prevent the door or lid from being opened. The home smithy.

This should resolve the issue. Replacing the door lock fixed it. At the conclusion of the cycle the control will activate the door unlock solenoid or will deactivate the door lock wax motor. If the door or lid won t open at the end of the cycle then the lock mechanism may be at fault.

To correct the situation shut off the circuit breaker for 30 seconds or unplug the washer then turn the timer knob around and back to any position other than final spin. The bill stuck in the drain system will cause the unit to not open. Once the washer door is closed the washer can begin operating. Inspect the door lock for damage.

If the above recommendation does not correct the situation service will be required. Our front loader door won t open and won t go into service mode. Ensure the water is on and turn the power back on which should solve the issue. Other potential causes include problems with the wiring or the main electronic control board or with the washer s door hinge.

Best priced door lock for this ge.