Ge Washing Machine Door Locked And No Power

Wait approximately 30 minutes for the oven to cool and try to unlock the door.

Ge washing machine door locked and no power. Best priced door lock for this ge. This is the most common solution for top loaders. I show the symptoms. If the washer is getting power but doesn t start the switch that senses whether the lid or door is shut or locked might have failed.

If door does not unlatch and you do not have food in the oven set the oven up to clean for 1 2 hours. Reconnect power and see if door will unlatch. The door should unlock. To unlock the washer controls press and hold the lock button for 10 seconds.

If pausing the cycle doesn t unlock the door turn the machine off. Our front loader door won t open and won t go into service mode. Then unplug the machine and wait 5 10 minutes. The only way to determine if the control board is at fault is to visually inspect it.

Whatever the model if your machine is stuck in a cycle try to reset the ge washer first. With the lower access panel removed and the washer unplugged reach up to the door lock and feel for a round release ring and pull it down. A failed timer main electronic control board user interface board or motor control board can also prevent the washer from starting. Go ahead and try running another load.

To lock the washer press and hold the lock button for 10 seconds. See the image below for how to do this. Check for burned areas or any component on the board that may look burned or damaged. Turn the washing machine off and unplug it.

To manually unlock the door on this washer you first unplug the washer from the wall outlet and then remove the lower access panel. If the water does not drain from the unit it tells the main control board that it is not empty and locks the door until it gets the signal that the unit is empty. If the main control board does not properly control the motor the filling valve the drain motor or the door lock the washer will not start. The bill stuck in the drain system will cause the unit to not open.

The home smithy. The motor may need to be reset if there is a power spike a load that is unbalanced or a disruption in power. Replacing the door lock fixed it. For other models of ge washing machines a pause in a cycle will cause the electronic controls to lock up.

Try pulling the handle again to see if the door opens.