Genie Garage Door Sensors Not Lit

Press and hold the wall console button until the garage door is completey closed.

Genie garage door sensors not lit. You can choose to press the close button located on the wall of the garage or the remote button. The sensors have to be aligned with each other and also have to be connected correctly to the garage door system in order to work. The transmitters remotes will not work to close the garage door. According to liftmaster issues with the safety sensor wiring typically occur because of a poor connection incorrectly connected wires or a short in the wire from a staple.

If the problem persists check to see if the red safe t beam led indicator is blinking. The genie safe t beam system is designed to ensure maximum safety for your garage door opener operation. If it is be sure that the lenses are mounted five to six inches from the floor on either side of the garage door opening. This replacement garage door safety sensor kit uses an invisible infrared beam across the opening of the door the system detects any object passing through the led beam of light and automatically reverses the closing garage door.

If an operational problem exists and the garage door opener will not close the opener can be forced to close. Raise the garage door using the control button on the garage wall or the remote control unit from a vehicle. It should be on and steady. See safe t beam diagnostic light guide check garage door for binding.

Ensure that the door is open and activate the opener. You will find that the door will only move an inch or so in the close direction and reverse. If you do not hear a click coming from the motor housing then the relay on the circuit board is bad. The problem is either due to a blocked path between the sensors dirty eyes loose wires at the sensors or at the motor head or just bad sensors.

If one or both of the lights are off check the fuses breakers and plugs for problems. The circuit board on your garage door opener will have to be replaced if you want your light to function properly. If both the red source and green sensor lights are on and not blinking then the door mechanism is working properly. Other signs include flashing garage door opener lights missing sensor light or flashing sensor lights.

Here s how to tell if garage door sensor is bad five things to check. Check the mechanism s source and sensor leds. Okay now that you know some of the common signs of garage door sensor malfunction you re ready for the next step troubleshooting. In this case check the alignment of the opener or better involve a technician.

Inspect each sensor to make sure the green or red power indicator lights are. If the garage door closes it indicates that the sensors are not functioning.