Genie Garage Door Won T Close With Remote

If the beam is broken or the sensors are misaligned the sensor light s will go off and subsequently tell the operator not close the door.

Genie garage door won t close with remote. This also disables any remotes or wireless keypads. To reprogram your garage door remote locate then press your opener s learn button. Genie garage door opens fine but does not shut. The transmitters remotes will not work to close the garage door.

Replace the genie remote if needed. Your garage door may be disconnected from the opener. See your owner s manual for more details. But if the remote is activated very very close to the unit while standing on a ladder and putting remote right next to the antenna and unit then it works and it activates closes the door even while the light is on.

The first thing to check is the transmission receiver on the inside wall of your garage. Genie openers apply only limited force to the garage door during closing. Try using your remote to open or close your door to determine if the reprogramming was successful. Garage door closes a little and back returns.

The garage door may attempt to go down but will come right back up and the overhead light on the garage door opener will blink. Turn the close force dial in small increments until the garage door reaches the ground when you hit the close button on the remote. If your garage door won t open with remote activation the problem could be the result of an expired battery in your remote transmitter. You will find that the door will only move an inch or so in the close direction and reverse.

Reprogram the remote to the power head. When this happens your garage door will only close by holding down on the wall button or wall console until the door fully closes. Check all remotes if all the remotes and wireless devices stopped working at the same time this could indicate the circuit board needs replaced replace the remote battery if neccesary. Genie garage door opener doesn t close.

Then within 30 seconds hold the button on your remote for three seconds or until garage door opener s lights flash or the led light on your opener blinks. When you manually push the button on the receiver does the door activate. Check that the emergency release cord has not been pulled. The door won t reach the ground if the maximum level of force is exceeding during closing.