Genie Garage Door Issue Learning Led Stays On

If the green indicator light stays on contact genie customer service.

Genie garage door issue learning led stays on. Allow roughly 10 minutes to troubleshoot your garage door opener. First be sure that the lenses are clean and check for any possible obstructions or loose wires. Go to the learn button on your garage door opener. Check if the limits are properly set.

A flashing safe t beam led indicator means a malfunction has occurred. If your door control has multiple functions check the light button on the panel. Try pressing it again to turn it off. If the lightbulb was the problem a genie led lightbulb will resolve this issue garage door starts down then stops and goes back up or safe t beam system malfunction.

The button is usually right next to the area the floppy antenna is connected to the motor head. The green led light will turn on then off when power is applied to the garage door opener. Sometimes the light switch button is accidentally activated which causes the light to stay on. Safe t beam is a government required safety feature that must be installed in order for your genie garage door opener to work.

With genie it is most often behind the light lens and flashes red when pressed. The status led indicator light is located under the lens cover. If you are experiencing problems with the interior light on your genie garage door opener you can run through some troubleshooting steps to try and resolve common faults. If it is blinking you can start by using the diagnostic blink codes below to troubleshoot.

Make sure only the safe t beams that came with this garage door opener are installed. Your door control panel is usually on the wall inside your garage.